T&I Engineer H/F

Role Definition

The role will liaise with:

• T&I Managers
• T&I pin-pile installation engineer
• Junior T&I engineer
• Logistic Engineers

The Service Provider shall perform the following activities as state below:

Activity 1: Support to the T&I team on installation works during EPCI Engineering and Installation phase. (on weekly basis)

• Collaborate with interdisciplinary teams, including structural engineers, geotechnical engineers, hydrologists, and project managers, to ensure successful project execution.
• Communicate effectively with T&I Manager, and contractors, to convey technical information and project updates.
• Provide technical expertise and support to colleagues and team members.

Activity 2: Support on the grouting strategy process and grouting execution works. (From now to the end of execution of works offshore Weekly basis)

• Support the Equipment expert and remaining T&I team in the development of the grouting strategy.
• Lead the communications with the Laboratory responsible for the grouting tests and ensure internal alignment with Certification Engineer.
• Follow up potential additional tests (higher temperature and/or testing with greater motions during the first 3h), or follow up even in case of redoing the tests already made and which led to the “decolouration default”.
• Interpret and follow up on the grout “strength curves” produced by the Contractors. Control the results of the grout “strength curves” Support on technical and design clarifications
• Address any technical issues or modifications required during construction.
• Identify areas for improvement.

Activity 3: Maintaining the necessary trackers

(From now to the end of execution of works offshore Weekly basis)

• Support with update of the tracker whenever interactions with DEME and Boskalis occur, comments are sent back and ensure that within Project team, all comments are fully integrated.

(April 2024 – March 2025), weekly)

• Review all As-built submitted within T&I for NOY and TRE OWF, keeping a track of all as-built and reports, as well as their status.
• Consolidate and distribute the as-built to the engineer in charge of the live update of Field layout master drawing.
• Prepare NCR when needed

Activity 4: Consolidation of DPRs, installation vessel weather stand-by

(During execution (April 2024 to march 2025), daily)

Activity 5: Other tasks

(From now to the end of execution of works offshore Weekly basis)

Support the review of documentation and preparation of reports and Notes Preparation of monthly activity reports

Participation to Meetings & Workshops

In order to ensure a continuous communication between the Client and the Service Provider, a series of meetings will be organised by Client throughout the duration of the Contract. Attendance and participation to these meetings will be key to ensure communication and alignment between the parties.

Coordination Meetings

Among the recurrent meetings organised by Client, the Service Provider may be requested to attend to monthly coordination meetings. These meetings will aim at:

• Measuring performance of the Contract execution,
• Reviewing upcoming needs for additional activities and termination of on-going activities as the case may be,
• Holding discussions on challenges, difficulties, lessons learnt.

From time to time, the coordination meetings could be face-to-face meetings held in the Client’s offices in Paris-La Défense and/or Lille. However, if jointly agreed, those meetings will normally be held through conference call or teleconference call.

Note:

• The agenda of coordination meetings is at this stage preliminary and will be fine-tuned all along contract execution,
• The frequency of these meetings may vary (increased, decreased or even suspended) during periods when exchanges do not seem to be necessary.

Adhoc Meeting & Workshops

In addition, various ad-hoc meetings or workshops will also take place. If Client judges it relevant, the Service Provider will be requested to attend to these ad-hoc meetings.

Qualification